Parapet Holder Clamp

Nylon Parapet Conductor Clamp /Parapet Holder Clamp (ARK-PH08) is an ARK external lightning protection component manufactured by DFMHUB in India. It retains a round lightning conductor along parapet surfaces while keeping the route orderly and accessible for inspection. The product is intended for engineered lightning protection installations on commercial, industrial, residential, infrastructure, data-centre and solar projects. It gives procurement and site teams a defined catalogue item instead of an improvised site-made part.

A conductor fastener is a safety-relevant part of the installed system because poor restraint can change conductor routing, stress a joint or make inspection difficult. The holder must match the conductor, roof or wall interface and exposure conditions. The fixing to the building fabric must also be engineered for the actual substrate; component compliance alone does not validate an unsuitable anchor or roof detail.

DFMHUB supports the ARK range as a manufacturer, with controlled drawings, repeatable fabrication or assembly, dimensional checks and project-specific technical coordination. Material grade, dimensions, finish, fastener configuration and any required test evidence should be frozen in the approved technical submittal before production. This approach helps consultants, EPC teams and contractors compare the offered component with the BOQ, installation detail and environmental exposure rather than relying only on a product name.

Technical Specifications • Neat support for exposed parapet routes • Non-metallic body helps separate conductor from the mounting surface • Simple inspection of conductor seating • Repeatable mounting across long roof perimeters

During installation, keep the conductor seated without damaging its surface, maintain the route shown on the approved drawing and use the specified anchors and torque. Coordinate penetrations with waterproofing requirements. The completed route should remain visible and accessible for periodic inspection, especially after roof work or severe weather.

Selection note: Verify conductor diameter, parapet material, anchor type, exposure conditions, fixing interval and movement allowance before installation. The applicable system layout should be prepared by a competent lightning protection designer and coordinated with the structure, roof system, services and earthing network.

For quotations, submit the product code ARK-PH08, required quantity, conductor or interface dimensions, material preference, project location and approved drawing. DFMHUB can then align manufacture, inspection records, packing and delivery with the project requirement.